Tread design offers optimum grip on mixed terrain.
Puncture resistance
The 27 TPI Skinwall carcass ensures tyre is well reinforced.
Efficiency
The structure of the knobs offers very little rolling resistance.
Compatibility
For 26" inner tubes and wheels.
Weight
820 g.Stiff bead.
Waterproof
Use with inner tubes only.
TECHNICAL INFORMATIONS
How to measure tyre wear?
To measure the wear on your tyres and to know when they need replacing, you need to inspect the tread. The tread comes into direct contact with the terrain you are cycling on and therefore determines your tyre's performance.
A tyre needs to be changed when the centre knobs are worn down to the same height as the side knobs.
How to remove a tyre
To remove your tyre, first deflate the inner tube until no more air comes out.
Once deflated, use a tyre lever to remove the tyre from the rim.
How to fit a tyre
To put the tyre back on, place one side of the tyre into the bottom of the rim. Next, inflate your inner tube to approximately 30% before putting it into the tyre (inflating it beforehand reduces the risk of pinching the inner tube). Then, place the other side of the tyre into the rim, starting on the side opposite the valve. Before inflating the inner tube all the way, check to make sure it isn't pinched between the tyre and the rim.
How to inflate your tyre correctly
Inflate your tyre with caution. The recommended pressure is indicated on the side of your tyre as well as on its product sheet (available online). Before each outing, make sure that your tyres are at the correct pressure for your ride.
Tip from the pros
When inflating your tyre, be sure to inflate it to the correct pressure for the terrain you will be riding on and especially the weather conditions. When riding in rainy weather, lower the tyre pressure to increase the tyre's traction. On the other hand, when riding in dry weather, increase the pressure for better performance.
Bought 4 of these for two mountain bikes. I’ve had trouble with all four. When put on the wheels, and inflated, they are just not even, so you get a lot of wobble. You can see it when you spin the wheel. Tried re-fitting many times, but no joy in resolving. Looks to me like a manufacturing fault. On all tyres, the side wall seems to be a different height measurement around the area where the printed logo is. Put the old tyres back on the wheels for now - at least they are perfectly round!. Will be taking these back to the store once it is opened for a refund.